Deluxe Ding Massager Kit
модель :
ABT-00119
ABT-00119
Deluxe Ding Massager Kit
● Clean the dent area and select the appropriate dent connector pad.
● The connector pad should match the size of dent area.
● Plug the glue gun,be caution the tip of glue gun temperature can reach approximately 165-200 degress.
● Place a large drop of glue on the connector pad.
● Apply the glue on the surface evenly and quickly press on the dent area.
● Don’t press to hard so the glue will form a thick layer between the dent area and connector pad.
● When the glue and connector pad is set,slide the t-bar hammer slowly and steadily until the dented area restored.
● Apply the cleaning polymer to soften and remove the glue layer that remains on the surface.
● Apply the razor plastic tool to clean the glue.
● Clean the restored area and polish the area.
● For mini puller: For small spot dent area you may apply the mini dent puller for better performance.
Step:
● Apply the glue on the surface evenly and quickly press on the dent area.
● Apply the mini dent puller on the connector pad.
● Adjust the height of central pulling bar.
● Apply the pulling tool until the dent area restored.apply the cleaning
polymer to soften and remove the glue layer that remains on the surface.
Deluxe Ding Massager Kit
● Clean the dent area and select the appropriate dent connector pad.
● The connector pad should match the size of dent area.
● Plug the glue gun,be caution the tip of glue gun temperature can reach approximately 165-200 degress.
● Place a large drop of glue on the connector pad.
● Apply the glue on the surface evenly and quickly press on the dent area.
● Don’t press to hard so the glue will form a thick layer between the dent area and connector pad.
● When the glue and connector pad is set,slide the t-bar hammer slowly and steadily until the dented area restored.
● Apply the cleaning polymer to soften and remove the glue layer that remains on the surface.
● Apply the razor plastic tool to clean the glue.
● Clean the restored area and polish the area.
● For mini puller: For small spot dent area you may apply the mini dent puller for better performance.
Step:
● Apply the glue on the surface evenly and quickly press on the dent area.
● Apply the mini dent puller on the connector pad.
● Adjust the height of central pulling bar.
● Apply the pulling tool until the dent area restored.apply the cleaning
polymer to soften and remove the glue layer that remains on the surface.
